Cannole linear module from Emu

The Cannolè seating system by Anton Cristell and Emanuel Gargano has a fully welded structure made of galvanized steel tubes inside and out. The seat consists of a galvanized bar grid welded to a bar frame. The legs are made of tubular steel. Pre-treatment and finishing with MIG welding, degreasing and cataphoresis with thermosetting polyester powders. The collection consists of: Corner modular sofa, linear modular sofa, stool, low armchair and low table. All Cannolè cushions are made of polyurethane rubber to which a layer of polyester fiber resin is added. All cushions are wrapped in a water-repellent inner cushion cover made of polyamide.

Avoid prolonged contact of this fabric with grease and dyes, which could be absorbed by the covering material and cause permanent stains and wear of the yarn structure. If used by the sea or near swimming pools, regular washing is recommended. Frequent washing: For each material, follow the specific instructions on the label. Wash with water and non-abrasive, colorless and pH-neutral liquid detergent. If necessary, leave the detergent to work for a few minutes. Rinse with plenty of water at a maximum temperature of 30°C. When using pressure equipment, keep the tip of the diffuser at a distance of at least 60-70 cm from the product surface. Repeat the process if necessary. Do not use scouring pads to remove stains. Do not bleach. Do not treat with chlorine.